Forklift Battery Charger Cross Reference by Brand
We do not sell charger units badged by the forklift manufacturer. We do not need to — an industrial battery charger is matched to the battery, not to the badge on the truck. A 36V 600Ah pack charges the same way whether it sits in a Crown, a Toyota, a Hyster or a Raymond. What follows is how to pick the right charger for your truck, whoever built it.
The four things that decide the charger
- Battery voltage. This must match exactly. Read it off the battery nameplate, not the truck's model number — the same truck model is often sold with more than one pack.
- Amp-hour capacity. This sets the output current you need. A conventional overnight charge is usually sized near 16 to 20 percent of the pack's amp-hour rating. Opportunity and fast charging run higher, and the battery has to be rated for it — check the battery manufacturer's limit before sizing up.
- Supply at the charging bay. Single phase chargers run on 110VAC or 220VAC standard shop power. Three phase chargers take 220VAC, 480VAC or 600VAC and reach much higher output. This is usually the constraint that decides the model, not the truck.
- Connector. Most industrial packs use an Anderson SB-series connector, commonly SB175 or SB350, and some fleets use Rema. Match the housing and the colour key to the battery, not to the old charger.
By forklift brand
Every major electric lift truck builder uses the same standard traction voltages, so the voltage pages below cover all of them. Confirm the voltage on your battery nameplate first.
Crown
Crown electric trucks span walkie and rider pallet trucks, order pickers, reach trucks and counterbalance models. Walkie and pallet equipment is typically 24V; order pickers and reach trucks typically 24V or 36V; counterbalance models typically 48V, with larger units at 80V.
Toyota
Toyota's electric range runs from pallet and walkie equipment through 3-wheel and 4-wheel counterbalance trucks. Pallet equipment is typically 24V, 3-wheel counterbalance typically 36V or 48V, and larger 4-wheel counterbalance 48V or 80V.
Raymond
Raymond is strongest in narrow-aisle equipment — reach trucks, order pickers, swing-reach and walkie pallet trucks. These typically run 24V or 36V packs, with some larger reach and turret trucks at 48V.
Hyster and Yale
Hyster and Yale share a great deal of electric drive engineering. Walkie and pallet equipment typically runs 24V; narrow-aisle and smaller counterbalance trucks 36V or 48V; and larger counterbalance models 80V.
Clark
Clark's electric counterbalance and narrow-aisle range typically runs 24V and 36V on smaller equipment and 48V or 80V on counterbalance trucks.
Linde
Linde electric trucks typically run 24V on pallet and walkie equipment, 48V across most counterbalance models, and 80V on the larger counterbalance range.
Shop by battery voltage
- 24 volt forklift battery chargers — 50A to 300A
- 36 volt forklift battery chargers — 45A to 300A
- 48 volt forklift battery chargers — 40A to 300A
- 80 volt forklift battery chargers — 20A to 200A
72V and 96V models are also available in the full forklift battery charger range.
Not sure which one you need?
Send us the battery nameplate — voltage, amp-hour rating and cell count — along with the supply available at the charging bay, and we will tell you which model fits. Call 717-421-9988.
Electric Drive Solutions
Matt Potter, Owner
717-421-9988